Use 2nd PH probe on Apex Classic

[john08007]

I have the apex classic, the 2nd port says ORP/PH, how do I set this up as a PH probe? I went through the setup and fusion and don't see anything about making it an PH or an ORP probe

[zombie]

You have to do it on the probe setup page of the classic dashboard.

Sent from my SM-G965U using Tapatalk

[john08007]

Do you mean on the controller attached to the apex? I scrolled through it, i saw where i can set up the 1st ph probe, then the orp probe, but nothing to switch between orp/ph. Then i have fusion on my phone/computer, cant find anything on there.

[zombie]

Do you mean on the controller attached to the apex? I scrolled through it, i saw where i can set up the 1st ph probe, then the orp probe, but nothing to switch between orp/ph. Then i have fusion on my phone/computer, cant find anything on there.

No. Enter the ip address of your apex into your browser. It's the same place you did initial setup for the apex and is also the only place you can make virtual outlets, edit the season table, configure modules, etc.

Sent from my SM-G965U using Tapatalk