Help with PMUP programming.
I am trying to use the PMUP to send water from my RODI holding container to my auto top off reservoir.
I have the Apex Classic and using 2 FMM modules, Breakout Box, and the PMUP in the setup.
I have searched the forums and found similar programming however, I am missing a step as the programming is not working how I would like it to work.
Here is my programming:
Fallback OFF
Set OFF
If ATOBot OPEN Then ON
If ATOTOP CLOSED Then OFF
When On > 005:00 Then OFF
Defer 000:10 Then ON
Defer 000:04 Then OFF
Min Time 060:00 Then OFF
The PMUP is using the 24vDC port in one of the FMM modules.
The ATOBot is a float sensor wired into the breakout box to determine when the water level is low in my ATO reservoir.
The ATOTOP is an optical eye plugged into the 2nd FMM module and is used to determine when the water level in my ATO reservoir is full.
Scenario:
ATOBot changes to open status and the PMUP turns on and begins to pump water into my ATO. However once the float changes to closed status the PMUP turns off.
How do I get the PMUP to continue adding water to my ATO until it reaches full status and the ATOTOP sensor changes to closed?
This is the first time I have posted a question, hopefully I have included all the necessary information. I have utilized the forum for quite some time and have learned a lot.
Thank you for any assistance.
Bookmarks