I'm having issues with this unit. Its installed on a 135 gallon tank with no sump.
It obviously needs to run longer than the default time to fill the tank, because it's a larger surface area than a typical sump chamber would be. I've tried to extend the run time, but now it runs and lets the water level get to the high sensor before shutting off. It's running every hour even though the first sensor is still covered.
Here's how its programmed, any advice on how to change it?
Fallback OFF
Set OFF
If Swx2_1 OPEN Then ON
If Swx2_2 CLOSED Then OFF
If Swx2_3 CLOSED Then OFF
When On > 015:00 Then OFF
Defer 000:10 Then ON
Defer 000:15 Then OFF
Min Time 060:00 Then OFF
Bookmarks