Hello everyone! I am new to the world of Apex and have been messing around with my new Apex EL for the last couple days. I set up my ATO, Return Pump, etc. However, I want to set up my heater so that it turns off if less than watts and greater than amps. I set my Amps lower than normal on purpose to test and it does turn my heater output off but I cannot get it to turn back on in Auto. When I turn it to on then it will stay on but when I turn to Auto it will revert back to Off.
I also want my heater to turn off if I shut down my retun pump for water changes, feedings, etc.
See programming below. Is this correct?
Fallback OFF
If Tmp < 77.8 Then ON
If Tmp > 78.0 Then OFF
If Output RETURN_PUMP = OFF Then OFF
Set OFF
If Output SUMP_HEATER Watts < 250 Then ON
If Output SUMP_HEATER Amps > 2.8 Then ON
Bookmarks