Originally Posted by
2mk
Thanks for the reply vhung168,
I am trying to determine if these statements are correct:
The lines below in the left and right DOS:
If Sw1 CLOSED Then OFF
If Sw2 CLOSED Then OFF
Will the above lines allow both left and right pumps to run when the reservoir bucket is full, while the waste reservoir is empty?
And will the above lines stop both left and right pumps when the resevoir is empty while the waste reservoir is full?
And the line below in the email alarm
If Sw1 CLOSED Then ON
If Sw2 CLOSED Then ON
Will the above line trigger the alarm?
Apex suggested to use these lines when using a breakout box with float switches. The program does work but i don't know if that is how I program the float switches to prevent accidents of pumping water out of tank while pumping nothing into the tank when the reservoir bucket is empty.
Bookmarks