So the ATO was going fine until recently-made a couple of small changes and then this behavior now happens:
If the pump activates -it will go to the full two minutes (I reduced it from five) regardless if the lower optical switch closes-
Then it goes to “off” from auto.
So I have to manually turn it back to auto in which the process repeats itself-
I took off the set=off per something that Russ had posted.
Code below. Any input appreciated.
Lawrence
Fallback OFF
If LOWATK OPEN Then ON
If ATO_OP OPEN Then OFF
If HI_ATK CLOSED Then OFF
When On > 002:00 Then OFF
Defer 000:10 Then ON
Defer 000:04 Then OFF
Min Time 060:00 Then OFF
Sent from my iPhone using Tapatalk
Bookmarks