Results 1 to 3 of 3

Thread: Icecap interface model won’t work help

  1. #1
    New User
    Join Date
    Feb 2019
    Location
    Virginia
    Posts
    2

    Icecap interface model won’t work help

    I hooked up the Icecap interface module and the gyre 1k with the battery backup. I have double checked all connections to the diagram.

    i don’t remember the powerhead running 100% in calibration mode.

    When I go into the apex and cut both variable speed ports to on the blades will occasionally rotate about 2 turns slowly and stop. The red light is blinking on the interface module. I have the Y cable but will be switching to the single so I can change direction but don’t have it now. I switched them to the on position to rule out programming issues.

    Any help is is greatly appreciated.

    Thank you

  2. #2
    Frequent Contributor zombie's Avatar
    Join Date
    Dec 2013
    Location
    Denver, CO
    Posts
    13,176
    Sounds like an issue with the interface to me. I would contact ice cap.

    Sent from my SM-G965U using Tapatalk

  3. #3
    Regular Vistor
    Join Date
    Mar 2018
    Location
    netherlands
    Posts
    16
    have you tried the gyre with te original controller ?
    is the gyre clean ?
    disconnect the gyre from the icecap and connect to power after few minutes disconnect power en reconnect gyre, now reconnect power and the icecap will recalibrate
    if the gyre takes to much power te icecap stops it

Similar Threads

  1. Icecap Gyre Interface Module
    By kb27973 in forum Apex Programming for Vortech, Tunze, & Other Controllable Pumps
    Replies: 223
    Last Post: 11-27-2020, 18:18
  2. IceCap XF280 Interface Module
    By SeabrookZoo in forum Misc Aquarium Automation Discussions
    Replies: 8
    Last Post: 03-06-2019, 04:41
  3. IceCap Gyre Interface
    By Spdjnky in forum Misc Apex Usage & Programming
    Replies: 29
    Last Post: 01-01-2019, 15:17
  4. Help! IceCap Module Interface
    By mpjones1 in forum DIY
    Replies: 2
    Last Post: 09-07-2017, 17:27
  5. Help! Little help with IceCap Gyre interface and programming
    By tkiry1 in forum Apex Programming for Vortech, Tunze, & Other Controllable Pumps
    Replies: 4
    Last Post: 04-16-2017, 09:05

Tags for this Thread

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •