Hi all.
Never had a DOS before and AWC sounded amazing so I bought one for the new tank I just setup. I got the first critters in there Thursday so I wanted to start my DOS up and get AWCs going from day one. My plan is to do 2 Gallons per day between 8am and Noon. So... I have my DOS connected via a 1link cable to one of my EB832s. I got a new tile in Fusion that loks like a DOS pump.
I went to tasks and ran the calibration. It seemed to run fine without issue. Next I ran the AWC task. Put in the information it asked for and it seemed to configure the unit just fine. I now see this image with the names I gave it on my fusion page:
DOS_Head.jpg
After I did the calibration and the AWC tasks it changed that and showed the ml on each one that had been ran though it. The next day came and went... and the DOS looked like the image above. I clicked on one of the DOS heads that takes me to the logs and it showed nothing. I could go to the day before and it showed activity:
DOS_log_1.jpg
DOS_log_2.jpg
So... I thought .. maybe since I set it up yesterday the timing was off or something and I'd be home today to see it. Didn't run again as far as I can tell. Log for today shows nothing and the DOS head shows nothing on it either and looks just like the image above.
I can see that it appears to be programmed ... it just doesn't seem to be running on it.
DOS_schedule_1.jpg
DOS_schedule_2.jpg
I'll post the last image in a reply to this one as it will only let me post up 5. But .. .as I said it seems like everything is "right" its just not starting when its scheduled to and actually doing a water change.
Let me know if you want/need caps of anything else... want to get this working so I'm happy to.
Thanks,
Brian
Bookmarks