How can I reset the Apex password? I purchased a used unit and the default is not working.
Thanks!
How can I reset the Apex password? I purchased a used unit and the default is not working.
Thanks!
Via the display module - System - Net Setup - Admin password. Make sure you reboot after changing it.
Al
I do not work for Neptune. Please do not send me PMs with technical questions or requesting assistance - use the forums!
For Neptune support send an email (don't call) to: [email protected] .
Manuals for all products including the Comprehensive Reference Manual can be found here.
awesome! Thanks!
i also have a password issue. just now happened and im locked out of my display unit. had to set the unit down and some buttons got pressed. now its demanding a password to acces my tank controller. need help!!!
There's a display password - try xyz
Al
I do not work for Neptune. Please do not send me PMs with technical questions or requesting assistance - use the forums!
For Neptune support send an email (don't call) to: [email protected] .
Manuals for all products including the Comprehensive Reference Manual can be found here.
thank you aquamanic! crisis adverted! thanks a ton. started to panic!
Forgot password, Display not working. Power went out, display is now dead (suspect I have to re-enable from the web interface), BUT haven't used the web browser in a long time, and forgot the password, which it seems like based on reading the only way to reset is from the display... which is dead... so I am stuck... is there a way to factory reset this? I tried the xyz, 1234, 1237 and other suggestions I found on the various posts but no luck...
Tripprea, you should contact tech support. Without you having access to the controller through the web pages or the display, we can't help you here.
Please do not send me PMs with technical questions or requesting assistance - use the forums for Apex help. PM me ONLY if the matter is of a private or personal nature. Thanks.
Thank you... I contacted them and they sent me a special firmware to factory reset and then I uploaded the new so I am back up and running.
Cool. That's what I figured they would do.
Please do not send me PMs with technical questions or requesting assistance - use the forums for Apex help. PM me ONLY if the matter is of a private or personal nature. Thanks.
Russ,
I pulled my JR out of the storage, plugged it in, shows in fusion and I get login screen locally. For the life of me I cannot remember the password and I dont have a display. What is one to do?
Thanks in advance.
If 'admin' & '1234' do not work, and you do not have or cannot borrow a display, then your only option is to do what I already suggested a few posts back in this thread
Please do not send me PMs with technical questions or requesting assistance - use the forums for Apex help. PM me ONLY if the matter is of a private or personal nature. Thanks.
...the firmware reset from Neptune.
Thanks.
Borrowed the screen from another system and guess what, it was the default admin/1234, logged in without any issues today. It's freaky and I don't like freaky.
Already updated the software this morning, went without a hitch.
Thanks for your help RUss.
Bookmarks