This thread is really old and I need to know if any recent problems have been reported. I haven't been successful inn connecting my radions to apex.
+2 for the above ...Just bought the WXM Module I did the firmware upgrade to my Apex.
After following the links it takes you to here:
http://www.neptunesystems.com/radiongs/
Following this direction cannot reset Radion light to WXM moduel ( won't turn of and on )!
I'm at the 4.10 mark on the video.
ESL is the Ecotech way to program radions , have a look to your radions instructions manual .
Alain
Can it be done here at the bottom reset Radion?
https://www.dropbox.com/s/lhw370ndit...pture.PNG?dl=0
Yes normally it can be done from there , you should re-read my post #4 .
Alain
OK got them showing on my Fusion , but both lights showing they are missing on dashboard..
Now showing 99% on both light after unplug/plug WXM from apex.
Have you tried to operate the outlet ON-OFF and check the result ?
Alain
So if you can turn them ON-OFF they are connected , you can program them .
Alain
Thanks will do been looking at some of these programs.
https://forum.neptunesystems.com/sho...n-FUSION/page3
I'm lost , not sure what to use!
ps I don't have a Par meter.
I am trying two new Radions to my Apex. I went it to update the WXM first and it is not showing in my list of modules, but yet my two existing Radions are working. When I go into configure modules, it says the WXM is there and I tried updating it and the apex says that it is now updated. When I run the Ecotech update, I get the 6fe error. When I try to attach Radions, nothing happens. When I was trying this, it turned the two new Radions off and they never came back on.
I also don't see the page in Fusion where I attached the Radions.
Hey guys i have 3 xr30 pro radions on my system. i am having issues with 2 of my Radions showing as "missing" AFTER they were added couple of days ago using WXM and working smoothly on fusion. Yesterday i added my 2 Vortech pumps on WXM and that is the only change i did. However my 3rd radion shows OK on the WXM configuration page under my controller web interface. Can someone help get the other two back on fusion. Thanks.
Bookmarks