I am adding an ozone reactor to my system to help manage the ORP. The probe is installed, and recording. I then go to program the ozone unit's socket in the EB8.
I have it set as follows:
Outlet Name: Ozone
Control type: ORP Control
Icon: Arrows
Fallback: off
Probe name: ORP
High Value: 250
Low Value: 200 (YES, I KNOW THESE VALUES ARE LOWER THAN WHAT SOME RECOMMEND, But, my current ORP is 175, so, I don't want to raise it to a high level quickly!)
On When:
The problem comes in when I try to make it default to ON when LOW. No matter how many times I change the default from HIGH to LOW, and hit apply, the value will NOT CHANGE to low after the apex refreshes the screen after applying. If I apply settings to any other settings on the controller, it will properly apply the settings after refreshing the screen.
What is wrong here?
Thanks,
Kirk
Bookmarks