Can I wire two door switches into one BoB switch so that if either door opens the light goes on? Just spice the together and run to one switch on BoB?
Can I wire two door switches into one BoB switch so that if either door opens the light goes on? Just spice the together and run to one switch on BoB?
Either way will work. From other threads, people do it both ways. I personally have each of doors wired to separate BoB switches, so I can turn on/off specific fans on that end of my cabinet when the door opens/closes.
Bert
Run multiple door/window sensors in series - one wire from first switch goes to BOB, second wire goes to second switch. Switch 2 connects to 3 and so on. Last switch, second wire goes back to ground on the BOB.
That way any switch opens and the entire circuit shows as open.
Also, put a 'Defer 1:00 then OFF' on the sump light outlet so if you close one door just to open another, the light isn't going on/off. All doors would have to be closed for 1 minute for the light to go off.
Al
I do not work for Neptune. Please do not send me PMs with technical questions or requesting assistance - use the forums!
For Neptune support send an email (don't call) to: [email protected] .
Manuals for all products including the Comprehensive Reference Manual can be found here.
Bookmarks