Hi, All.
So it seems the temp port on my PM1 has failed. When I plug a temp port into it, it's reading 50 degrees which is not correct. If I plug that same temp port into my Apex Classic directly it reads correctly. I was using the temp port on my Apex Classic for Water Surface Temp (To activate fans if cabinet gets too hot) and the Temp Port on my PM1 for Water Temp.
I've plugged the Water Temp Probe into my Classic and swapped over all of the code so now everything is controlled from the working port.
But now comes to the issue with my PM1. I've tried unplugging it, and also power recycling the controller. Any tips to figuring out why the port on the PM1 would all of a sudden read incorrectly?
Thanks,
Joey
Bookmarks